We are currently working on LifePresenceDetection_Capon2D demo, and we want to reduce the computation time spent on Capon, and because the application scenario does not need to appear too close or too ...

I am able to include the .h file easily in liker cmd file as shown below: Now i am working on how to include same .h file on .asm file. I tried couple of methods using below app notes but none of them ...

1. The principle of capacitive voltage sensor is shown in the picture: 2. The schematic diagram of the design, as shown in the picture: (The schematic only leaves a schematic diagram of one channel, ...

We want to execute PBIST and LBIST in MCU, so change the file below. Primary core: Main R5F0-0: Requesting processor Secondary core: Main R5F1-0: Requesting processor Primary core: Putting in module ...

In the attached single-supply inverting amplifier circuit, the output behavior differs when using "OPA211AID" and "OPA197." - With the "OPA211AID," the output remains unchanged, and the supply voltage ...

My customer is considering PGA870 and has questions. I would be grateful if you could advise. (1) I am considering using the DVGA PGA870 as a front-stage amplifier for an AD converter (ADC3223IRGZR).

My customer chose the DIX4192-a quite old device- to convert I2S signal to AES3(Balanced) and transmit to a bit distant slave board as below. My question is that a transformer is recommended to reduce ...

I'm writing this article because debugging a current measurement circuit using a shunt resistor, but the output instability has not been resolved. The shunt resistor in the diagram is a high-side ...

I want to add a transformer to my design, but I have encountered a barrier. I understand that there are at least three methods for adding a transformer: 1) add the part from a library, 2) create the ...

I have 120MHz RF Frequency with 10 DBm input power. can i give this frequency on INP1 and take output from all channel with the same power out. please let me know if is there any losses occur.

we want to make pwm1 and pwm2 sync, which are 50khz and pwm5--pwm12 sync,which are 18khz. we configurate the pwm module as follows, but pwm7 and pwm8 not output pwm signal. once ...

We used CCS Theia 1.3.1 command line for automatically building projects. Now we update the CCS Theia to 1.5.1. But we find that build command will not return error ...