Other Parts Discussed in Thread: AWR2243, 我在官方AM2732+2*AWR2243两片级联的Demo中导入了以太网模块，使能了CPSW，添加了PHY驱动以及LWIP协议栈。目前通过.map文件看下来，添加以太网模块前后MSS_L2空间占用情况如下： 添加以太网模块前： ...

1、M3与TCAN4550的SPI通信正常：表现为读DEVICE ID正常；初始化寄存器的时候进行写后，回读与写的值比较，均通过； 2、M3与 ...

I can't download my firmware(.out) to CC2745R10 EVB with LP-XDS110 download debugger.(I chose Part number:CC2745P10 because there is no CC2745R10.) Here is a my trouble shooting. 1. Hardware Setup Set ...

We have successfully interfaced the LDC5072-Q1 inductive position sensor with the metallic (Aluminium) target and as suggested by the In LDC5072_Sensor_Designer software, we followed the steps to get ...

I have collected data activating all 12 Tx and 16 Rx. I read all the bin files (master and slaves) using fread(fid, 'int16'). Total number of samples are correct as per the set parameters. Total ...

Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask ...

I have tried to download many times, include turn off anti-virus tool before starting download, but all got "Installer payload initialization failed. This is likely ...

I have a question about initGpio code. please refer below red color code. I think sizeof(GpioCtrlRegs) / 2 is wrong. sizeof(GpioCtrlRegs) / 4 is correct. because ...

Texas Instruments (TI) MSP low-power microcontrollers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search MSP low ...

Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask ...

Texas Instruments (TI) Sensors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search sensors IC content or ask ...

This has me a bit befuddled, and I will try to keep it concise, if you need any more information let me know. Thanks for your help. I am using a EPWM in High Resolution Mode. The EPWM is setup in up ...